0.05MM Foil Aluminium Honeycomb Sheet For Honeycomb Sandwich

0.05 mm Thick Foil Aluminum Honeycomb Core for Honeycomb Sandwich Composite Panel is made of degreasing treated aluminum foil of 0.05 mm thick bonded by special purpose adhesive with a cell side length 6 mm. It is used for regular aluminum honeycomb panel core structure. The performance of the aluminum honeycomb core is determined by the properties of aluminum foil, special purpose chemical adhesive and the size and configuration of the core.

Because of the train travells at a really high speed so the core should maintain a high strength. The spot welding or laser welding should be applied to the bonding technology if specially required.

Process

General process of an aluminum honeycomb core initiated with an aluminum foil roll and surely the foil is specially treated.

The adhesive tapes are printed to the foil surface with the intervals and width pre-determined by the cell size and strength requirement.

The foil paper is cut into required size to be piled up on the stacking table with equipment and man supervision on the adhesive tape positioning.

These stacked loose blocks should be pressed in a heated press to cure the adhesive so that the sheets of foil are bonded together to hardened block.

The aluminum honeycomb block can be cut into slices with the height of the slices tailored to customized requirements.

Finally, no matter it is done in supplier’s plant or at client’s workshop, the honeycomb should be expanded before forming aluminum honeycomb panel.

The following materials are for forming honeycomb cores:

1. Aluminum foil

Regularly, 3003H19/5052H18 aluminum alloy foils after strict surface treatment are used for producing aluminum honeycomb core.

2. Special Purpose Chemical Adhesive

Modified epoxy glue for high temperature cure process can provide not only sufficient bonding strength, but also environmental resistance and high or low temperature resistant properties. The joint strength of aluminum honeycomb core is the keypoint of evaluating the core’s performance. The minimum requirement should be more than 2.0N/mm.

Specification of Aluminum Honeycomb Core:

Specifications can be customized according to customer’s requirement.

Supply modes of Aluminum Honeycomb Core:

- Unexpanded block

- Unexpanded slice

- Expanded sheet

- Pieces cut to size